TROUBLE SHOOTING IN THE PRINT INDUSTRY

Concentricity tolerance too high

Concentricity tolerance too high

If the concentricity axial as radial is not given, it can influence the drive of the slitter and lead to breaks on the knives – especially with carbide knives.

  • Clean the knife holder
  • Replace bearings
  • Setup knives with torque wrench and tighten screws crosswise

Recommendation:
The concentricity should ≥0,03 mm axial and radial, the axial concentricity should be ≥0,01 mm on the anvil

 

de-png

Do you need further information?

We could not clarify your individual request, or you have a question concerning another topic?

Then we will be happy to help you by phone: +49 4532 400 0 or by e-mail at: info@tkmmeyer.com 

You can also send us your message using the following contact form.